✦ Powered by @ammora-protocol/sdk  •  v0.3.9

Swap in RGB,
on a clean white canvas.

Trade on GIWA Sepolia through Ammora’s auto-route pools. Get a live quote, check price impact, and confirm in your wallet — ETH wraps to WETH automatically.

$—Chain ID 91342
0.30%Swap fee
Auto-routeV4 generation
TestnetGIWA Sepolia only
You payBalance: —  
≈ $3,428.50
You receive (estimated)Balance: —
≈ $0.00
Slippage tolerance
Rate—
Price impact—
Minimum received—
RouteETH → USDC
NetworkGIWA Sepolia · 91342

Quotes use the Ammora SDK route logic for GIWA Sepolia. No funds move until you confirm in your wallet. This page is a testnet interface — not financial advice.

How it works

Built for the Ammora builder flow — same steps the SDK examples use: verify, quote, simulate, then send only after wallet confirmation.

1

Connect on GIWA Sepolia

Connect a wallet on chain ID 91342. Check you are on testnet — mainnet funds are never requested here.

2

Get a quote from the SDK

Pick a pair and amount. The route client reads on-chain pool state and returns the estimated output, impact, and minimum received after slippage.

3

Confirm & swap

Review the quote, then confirm in your wallet. Paying with ETH? It wraps to WETH automatically as part of the swap — no separate step.

# Install the SDK used by this interface
npm install @ammora-protocol/sdk@0.3.9

# Quickstart — exact-input swap (from Ammora Docs)
AMMORA_CHAIN_ID=91342 npx tsx safe-swap.ts <pool> <tokenIn> <amountIn>
Done